D-Link 3312SR Reference Manual - Page 198

DGS-3312SR Layer 3 Gigabit Switch config access_profile • dscp − Specifies that the access profile will apply only to packets that have this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet header. • icmp − Specifies that the switch will examine the Internet Control Message Protocol (ICMP) field within each packet. • type − Specifies that the access profile will apply to this ICMP type value. • code − Specifies that the access profile will apply to this ICMP code. • igmp − Specifies that the switch will examine the Internet Group Management Protocol (IGMP) field within each packet. • type − Specifies that the access profile will apply to packets that have this IGMP type value. • tcp − Specifies that the switch will examine the Transmission Control Protocol (TCP) field within each packet. • src_port − Specifies that the access profile will apply only to packets that have this TCP source port in their TCP header. • dst_port − Specifies that the access profile will apply only to packets that have this TCP destination port in their TCP header. • flag_mask - Enter the type of TCP flag to be masked. The choices are: • urg: TCP control flag (urgent) • ack: TCP control flag (acknowledgement) • psh: TCP control flag (push) • rst: TCP control flag (reset) • syn: TCP control flag (synchronize) • fin: TCP control flag (finish) • udp − Specifies that the switch will examine the Universal Datagram Protocol (UDP) field in each packet. • src_port − Specifies that the access profile will apply only to packets that have this UDP source port in their header. • dst_port − Specifies that the access profile will apply only to packets that have this UDP destination port in their header. protocol_id − Specifies that the switch will examine the Protocol field in each packet and if this field contains the value entered here, apply the following rules. 192