D-Link 3312SR Reference Manual - Page 285
config ospf virtual_link, Hello Interval, Authorization Type,
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
DGS-3312SR Layer 3 Gigabit Switch DGS-3312SR:4#create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10 Command: create ospf virtual_link 10.1.12 20.1.1.1 hello_interval 10 Success. DGS-3312SR:4# config ospf virtual_link Purpose Used to configure the OSPF virtual interface settings. Syntax config ospf virtual_link {hello_interval | dead_interval | authentication [none | simple | md5 ]} Description This command is used to configure the OSPF virtual interface settings. Parameters − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain. − The OSPF router ID for the remote area. This is a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area's Area Border Router. hello_interval − Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. dead_interval − Allows the specification of the length of time between the receipt of Hello packets from a neighbor router before the selected area declares that router down. An interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly divisible by the Hello Interval. authentication - Enter the type of authentication preferred. The user may choose between: none - Choosing this parameter will require no authentication. simple − Choosing this parameter will set a simple authentication which includes a case-sensitive password of no more than 8 characters. Restrictions md5 − Choosing this parameter will set authentication based on md5 encryption A previously configured MD5 key ID (1 to 255) is required. Only administrator-level users can issue this command. 279
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/285.png)