D-Link 3312SR Reference Manual - Page 147

DGS-3312SR Layer 3 Gigabit Switch

141

To create the method list “Trinity.”:

DGS-3312SR:4#create authen_login method_list_name Trinity

Command: create authen_login method_list_name Trinity

Success.

DGS-3312SR:4#

config authen_login

Purpose

Used to configure a user-defined or default

method list

of

authentication methods for user login.

Syntax

config authen_login [default | method_list_name <string 15>]

method {tacacs | xtacacs | tacacs+ | radius | server_group

<string 15> | local | none}

Description

This command will configure a user-defined or default

method list

of

authentication methods for users logging on to the switch. The

sequence of methods implemented in this command will affect the

authentication result. For example, if a user enters a sequence of

methods like

tacacs – xtacacs – local,

the switch will send an

authentication request to the first

tacacs

host in the server group. If

no response comes from the server host, the switch will send an

authentication request to the second

tacacs

host in the server group

and so on, until the list is exhausted. At that point, the switch will

restart the same sequence with the following protocol listed,

xtacacs

.

If no authentication takes place using the

xtacacs

list, the

local

account database set in the switch is used to authenticate the user.

When the local method is used, the privilege level will be dependant

on the local account privilege configured on the switch.

Successful login using any of these methods will give the user a

“user” privilege only. If the user wishes to upgrade his or her status to

the administrator level, the user must implement the

enable admin

command, followed by a previously configured password. (

See the

enable admin

part of this section for more detailed information,

concerning the

enable admin

command.)

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296

D-Link 3312SR Reference Manual - Page 147

config authen_login, config authen_login [default | method_list_name <string 15>] - dgs default password

Page 147 highlights