D-Link 3312SR Reference Manual - Page 162

DGS-3312SR Layer 3 Gigabit Switch

156

config authen server_group

±

radius

– Use this parameter to utilize the built-in RADIUS

server protocol on the switch. Only server hosts utilizing the

RADIUS protocol may be added to this group.

±

<string 15>

Enter an alphanumeric string of up to 15

characters to define the previously created server group.

This group may add any combination of server hosts to it,

regardless of protocol.

[add | delete]

– Enter the correct parameter to add or delete a server

host from a server group.

server_host <ipaddr>

- Enter the IP address of the previously

configured server host the user wishes to add or delete.

protocol

– Enter the protocol utilized by the server host. There are

three options:

±

tacacs

– Use this parameter to define the protocol if the

server host is using the TACACS authentication protocol.

±

xtacacs


server host is using the XTACACS authentication protocol.

±

tacacs+


server host is using the TACACS+ authentication protocol.

±

radius


server host is using the RADIUS authentication protocol.

Restrictions

Only administrator-level users can issue this command.

Example usage:

To add an authentication host to server group “group_1”:

DGS-3312SR:4#config authen server_group group_1 add server_host

10.1.1.121 protocol tacacs+

Command: config authen server_group group_1 add server_host

10.1.1.121 protocol tacacs+

Success.

DGS-3312SR:4#

delete authen server_group

Purpose

Used to delete a user-defined authentication server group.

Syntax

delete authen server_group <string 15>

Description

This command will delete an authentication server group.

Parameters

<string 15>

- Enter an alphanumeric string of up to 15 characters to

define the previously created server group the user wishes to delete.

Restrictions

Only administrator-level users can issue this command.

Example usage:

Section	Page
Introduction	7
	7
	7
Accessing the Switch via the Serial Port	7
Setting the Switch’s IP Address	8
Using the Console CLI	10
	10
	10
Connecting to the Switch	10
Command Syntax	16
Basic Switch Commands	18
Switch Port Commands	30
Port Security Commands	33
Network Management (SNMP) Commands	37
Switch Utility Commands	58
Network Monitoring Commands	62
Multiple Spanning Tree Protocol (MSTP) Commands	75
Forwarding Database Commands	88
Broadcast Storm Control Commands	95
QoS Commands	97
Port Mirroring Commands	105
VLAN Commands	110
Link Aggregation Commands	117
IP Commands (Including IP Multinetting)	123
IGMP Commands	128
IGMP Snooping Commands	131
MAC Notification Commands	139
Access Authentication Control Commands	143
SSH Commands	167
SSL Commands	175
802.1X Commands	180
Access Control List (ACL) Commands	192
Traffic Segmentation Commands	201
Stacking Commands	203
D-Link Single IP Management Commands	206
Time and SNTP Commands	216
ARP Commands	222
VRRP Commands	226
Routing Table Commands	233
Route Redistribution Commands	237
BOOTP Relay Commands	243
DNS Relay Commands	247
RIP Commands	251
DVMRP Commands	254
PIM Commands	259
IP Multicasting Commands	263
MD5 Configuration Commands	265
OSPF Configuration Commands	268
Command History List	288
Technical Specifications	290
	296
	296
	296
	296
	296
	296
	296
Copyright Statement: No part of this publication or documentation accompanying this product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Co	296

D-Link 3312SR Reference Manual - Page 162

config authen server_group, DGS-3312SR:4#config authen server_group group_1 add server_host

Page 162 highlights