D-Link 3312SR Reference Manual - Page 128
IGMP Commands, config igmp
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
DGS-3312SR Layer 3 Gigabit Switch 18 IGMP COMMANDS The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command config igmp show igmp show igmp group Parameters [ipif | all] {version | query_interval max_response_time | robustness_variable | last_member_query_interval | state [enable | disable] {ipif } {group } {ipif } Each command is listed, in detail, in the following sections. config igmp Purpose Syntax Description Parameters Restrictions Used to configure IGMP on the switch. config igmp [ipif | all] {version | {query_interval | max_response_time | robustness_variable | last_member_query_interval | state [enable | disable] This command allows you to configure IGMP on the switch. − The name of the IP interface for which to configure IGMP. all − Specifies all the IP interfaces on the switch. version − The IGMP version number. query_interval − The time in seconds between general query transmissions, in seconds. max_response_time − Enter the maximum time in seconds that the switch will wait for reports from members. robustness_variable − This value states the permitted packet loss that guarantees IGMP. last_member_query_interval − The Max Response Time inserted into Group-Specific Queries sent in response to Leave Group messages, and is also the amount of time between Group-Specific Query messages. The default is 1 second state [enable | disable] − Enables or disables IGMP for the specified IP interface. Only administrator-level users can issue this command. Example Usage: To configure the IGMP for the IP interface System. 122