D-Link 3312SR Reference Manual - Page 229
create vrrp ipif, config vrrp ipif
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
DGS-3312SR Layer 3 Gigabit Switch create vrrp ipif Restrictions critical_ip - Enter the IP address of the physical device that will provide the most direct route to the Internet or other critical network connections from this virtual router. This must be a real IP address of a real device on the network. If the connection from the virtual router to this IP address fails, a new Master will be elected from the backup routers participating in the VRRP group. If the connection to the backup fails, this backup router cannot assume the Master router role. Different critical IP addresses may be assigned to different routers participating in the VRRP group, and can therefore define multiple routes to the Internet or other critical network connections. critical_ip_state [enable | disable] - This parameter is used to enable or disable the critical IP address entered above. The default is disable. Only administrator-level users can issue this command. Example usage: To create a VRRP entry: DGS-3312SR:4#create vrrp ipif Darren vrid ipaddress 11.1.1.1 state enable priority 200 advertisement_interval 1 preempt true critical_ip 10.53.13.224 critical_ip_state enable Command: create vrrp ipif Darren vrid ipaddress 11.1.1.1 state enable priority 200 advertisement_interval 1 preempt true critical_ip 10.53.13.224 critical_ip_state enable Success. DGS-3312SR:4# config vrrp ipif Purpose Syntax Description Parameters To configure a VRRP IP interface on the switch. [authtype [none | simple authdata | ip authdata ] | vrid {state [enable | disable] | priority | ipaddress | advertisement_interval | preempt [true | false] | critical_ip | critical_ip_state [enable | disable]} This command is used to configure a previously configured VRRP interface on the switch. - Enter the name of a previously configured IP interface that you wish to configure the VRRP entry for. This IP interface must be assigned to a VLAN on the switch. vrid - Enter a value between 1 and 255 that uniquely identifies the VRRP group you wish to configure. All routers participating in this group must be assigned the same vrid value. This value MUST be different from other VRRP groups set on the switch. state [enable | disable] - Used to enable and disable the VRRP IP interface on the switch. priority - Enter a value between 1 and 254 to indicate the 223
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/229.png)