D-Link 3312SR Reference Manual - Page 278
show ospf aggregation, show ospf lsdb
![]() |
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
DGS-3312SR Layer 3 Gigabit Switch Usage Example To configure the OSPF area aggregation settings: DGS-3312SR:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary advertise enable Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary advertise enable Success. DGS-3312SR:4# show ospf aggregation Purpose Syntax Description Parameters Restrictions Used to display the current OSPF area aggregation settings. show ospf aggregation {} This command will display the current OSPF area aggregation settings. − Enter this parameter if you wish to view this table by a specific OSPF area ID. None. Usage Example To display OSPF area aggregation settings: DGS-3312SR:4#show ospf aggregation Command: show ospf aggregation OSPF Area Aggregation Settings Area ID -----------10.1.1.1 10.1.1.1 Aggregated LSDB Network Address Type 10.0.0.0/8 Summary 20.2.0.0/16 Summary Advertise ------------Enabled Enabled Total Entries: 2 DGS-3312SR:4# show ospf lsdb Purpose Syntax Description Parameters Used to display the OSPF Link State Database (LSDB). show ospf lsdb {area_id | advertise_router | type [rtrlink | netlink | summary | assummary | asextlink]} This command will display the current OSPF Link State Database (LSDB). area_id − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the 272
![](/manual_guide/products/dlink-3312sr-reference-manual-4c3c9f4/278.png)