D-Link 3312SR Reference Manual - Page 98
config bandwidth_control [<portlist> | all] {rx_rate [no_limit
UPC - 790069263873
View all D-Link 3312SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
DGS-3312SR Layer 3 Gigabit Switch Command show 802.1p default_priority config scheduling_mechanism show scheduling_mechanism Parameters {} [strict | round_robin] Each command is listed, in detail, in the following sections. config bandwidth_control Purpose Syntax Description Parameters Restrictions Used to configure bandwidth control on a by-port basis. config bandwidth_control [ | all] {rx_rate [no_limit | ] | tx_rate [no_limit | ]} The config bandwidth_control command is used to configure bandwidth on a by-port basis. − Specifies a range of ports to be configured. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. all - Choose this parameter to select all configurable ports. rx_rate − Specifies that one of the parameters below (no_limit or ) will be applied to the rate at which the above specified ports will be allowed to receive packets no_limit − Specifies that there will be no limit on the rate of packets received by the above specified ports. − Specifies the packet limit, in Mbps, that the above ports will be allowed to receive. tx_rate − Specifies that one of the parameters below (no_limit or ) will be applied to the rate at which the above specified ports will be allowed to transmit packets. no_limit − Specifies that there will be no limit on the rate of packets received by the above specified ports. − Specifies the packet limit, in Mbps, that the above ports will be allowed to receive. Only administrator-level users can issue this command. Example usage: To configure bandwidth control: DGS-3312SR:4#config bandwidth_control 1:1-1:10 tx_rate 10 Command: config bandwidth_control 1:1-1:10 tx_rate 10 Success. DGS-3312SR:4# 92