D-Link 3312SR Reference Manual - Page 72

DGS-3312SR Layer 3 Gigabit Switch config syslog host Parameters all − Specifies that the command will be applied to all hosts. − Specifies that the command will be applied to an index of hosts. There are four available indexes, numbered 1 through 4. severity − Severity level indicator. These are described in the following: Bold font indicates that the corresponding severity level is currently supported on the switch. Numerical Severity Code 0 Emergency: system is unusable 1 Alert: action must be taken immediately 2 Critical: critical conditions 3 Error: error conditions 4 Warning: warning conditions 5 Notice: normal but significant condition 6 Informational: informational messages 7 Debug: debug-level messages informational − Specifies that informational messages will be sent to the remote host. This corresponds to number 6 from the list above. warning − Specifies that warning messages will be sent to the remote host. This corresponds to number 4 from the list above. all − Specifies that all of the currently supported syslog messages that are generated by the switch will be sent to the remote host. facility − Some of the operating system daemons and processes have been assigned Facility values. Processes and daemons that have not been explicitly assigned a Facility may use any of the "local use" facilities or they may use the "user-level" Facility. Those Facilities that have been designated are shown in the following: Bold font indicates the facility values the switch currently supports. Numerical Facility Code 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 kernel messages user-level messages mail system system daemons security/authorization messages messages generated internally by syslog line printer subsystem network news subsystem UUCP subsystem clock daemon security/authorization messages FTP daemon NTP subsystem log audit log alert clock daemon 66