Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 148
port storm-control broadcast rate
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
www.dell.com | support.dell.com User Guidelines Use the port storm-control broadcast rate interface configuration command, to set the maximum allowable Broadcast rate. Multicast can be counted as part of the "storm" frames if the port storm-control includemulticast global configuration command is already executed. Example The following example enables Broadcast storm control on port g5. Console(config)# interface ethernet g5 Console(config-if)# port storm-control broadcast enable port storm-control broadcast rate The port storm-control broadcast rate interface configuration command configures the maximum Broadcast rate. Use the no form of this command to configure the default value. port storm-control broadcast rate rate no port storm-control broadcast rate • rate-Maximum of kilobytes per second of Broadcast and Multicast traffic on a port. (Rate: 0 - 1000000) Default Configuration The default storm control Broadcast rate is 12000. Command Mode Interface Configuration (Ethernet) User Guidelines Use the port storm-control broadcast enable interface configuration command to enable Broadcast storm control. The rate is rounded to the nearest 64 kbytes/sec (except 1 - 63 kbytes/sec, which is rounded to 64 kbytes/sec). Note that if the rate is 0, Broadcast packets are not forwarded. Example The following example configures the maximum Broadcast rate 10 kilobytes per second. Console(config)# interface ethernet g2 Console(config-if)# port storm-control broadcast rate 10 148 Ethernet Configuration Commands