Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 268

www.dell.com | support.dell.com Example The following example displays OSPF-related IP interface 192.168.1.1 information. Console# show ip ospf interface 192.168.1.1 IP interface 192.168.1.1/16 is up, OSPF is enabled Area 0.0.0.0, Router ID 192.77.99.1, Network Type BROADCAST, Cost: 10 Interface has simple password authentication Transmit Delay is 1 sec, State OTHER, Priority 1 Designated Router id 192.168.1.11, Interface address 192.168.1.11 Backup Designated router id 192.168.1.28, Interface addr 192.168.1.28 Timer intervals configured, Hello 10, Dead 60, Retransmit 5 Neighbor Count is 8, Adjacent neighbor count is 2 Adjacent with neighbor 192.168.1.28 (Backup Designated Router) Adjacent with neighbor 192.168.1.10 (Designated Router) The following table describes fields shown in the display: Field Description Transmit Delay Designated Router Backup Designated router Timer intervals configured Neighbor Count Transmit delay, interface state, and router priority. Designated router ID and respective interface IP address. Backup designated router ID and respective interface IP address. Configuration of timer intervals. Count of network neighbors and list of adjacent neighbors. show ip ospf neighbor The show ip ospf neighbor user EXEC command displays OSPF-neighbor information on a perinterface basis. Syntax show ip ospf neighbor [interface] • interface-The IP interface. Default Configuration This command has no default configuration. 268 OSPF Commands