Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 88
bridge multicast filtering, bridge multicast address
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
www.dell.com | support.dell.com Example The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on port g8 to the bridge table. Console (config)# interface vlan 2 Console (config-vlan)# bridge address 3aa2.64b3.a245 ethernet g8 permanent bridge multicast filtering The bridge multicast filtering global configuration command enables filtering of Multicast addresses. To disable filtering of Multicast addresses, use the no form of the bridge multicast filtering command. Syntax bridge multicast filtering no bridge multicast filtering Default Configuration Disabled. All Multicast addresses are flooded to all ports of the relevant VLAN. Command Mode Global Configuration mode User Guidelines If Multicast routers exist on the VLAN and IGMP, snooping is not enabled, the bridge multicast forward-all command should be used to enable forwarding all Multicast packets to the Multicast routers. Example In this example, bridge Multicast filtering is enabled. Console (config)# bridge multicast filtering bridge multicast address The bridge multicast address interface configuration command registers MAC-layer Multicast addresses to the bridge table, and adds static ports to the group. To unregister the MAC address, use the no form of the bridge multicast address command. Syntax bridge multicast address {mac-multicast-address | ip-multicast-address} 88 Address Table Commands