Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 360
SNMPv1/v2 Commands, snmp-server community, Console, OID Tree, user-filter
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 360 highlights
www.dell.com | support.dell.com Example The following example displays the configuration of filters. Console # show snmp filters Name ----------user-filter user-filter user-filter OID Tree 1.3.6.1.2.1.1 1.3.6.1.2.1.1.7 1.3.6.1.2.1.2.2.1.*.1 Type --------Included Excluded Included SNMPv1/v2 Commands snmp-server community The snmp-server community global configuration command sets up the community access string to permit access to the SNMP protocol. To remove a community or community group, use the no snmp-server community command. Syntax snmp-server community community [ro | rw | su] [ip-address][view view-name][type {router | oob}] snmp-server community-group community group-name [ip-address][type {router | oob}] no snmp-server community community [ip-address] • community-Community string that acts like a password and permits access to the SNMP protocol. (Range: 1-20 characters) • ro-Indicates read-only access (default). • rw-Indicates read-write access. • su-Indicates SNMP administrator access. • ip-address-Specifies the IP address of the management station. If no IP address is specified, all management stations are permitted. For information on specifying out-ofband IP addresses, see the user guidelines. • view-name-Specifies the name of a previously defined view. For information on views, see the user guidelines. (Range: 1-30 characters) • group-name-Specifies the name of a previously defined group. For information on groups, see the user guidelines. (Range: 1-30 characters) 360 SNMP Commands