Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 471

Example The following example configures the time between sending advertisements messages for VRRP as a number from 45 to 100 seconds on g8. Console(config)# interface ethernet g8 Console(config-if)# vrrp 45 timer 100 vrrp priority The vrrp priority interface configuration command configures Virtual Router Redundancy Protocol (VRRP) priority on an interface. To restore the default priority value, use the no form of this command. Syntax vrrp virtual-router priority priority no vrrp virtual-router priority • virtual-router-Virtual router number. (Range: 1 - 255) • priority-The priority used for the virtual router master election process. Higher values imply higher priority. (Range: 1 - 255) Default Configuration The default VRRP priority values are as follows: • Non-owner-100 • Owner-255 Command Mode Interface configuration (Ethernet, VLAN, port-channel) User Guidelines This command cannot be used with a range of ports. The owner priority cannot be modified, it is always 255. Example The following example configures VRRP number 45 priority to 150 on g8. Console(config)# interface ethernet g8 Console(config-if)# vrrp 45 priority 150 VRRP Commands 471