Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 458
switchport trunk native vlan, switchport general allowed vlan
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 458 highlights
www.dell.com | support.dell.com Example The following example shows how to add VLANs 2 and 5 to 8 to the allowed list of g8. Console (config)# interface ethernet g8 Console (config-if)# switchport trunk allowed vlan add 2,5-8 switchport trunk native vlan The switchport trunk native vlan interface configuration command defines the port as a member of the specified VLAN, and the VLAN ID as the "port default VLAN ID (PVID)". To configure the default VLAN ID, use the no form of this command. Syntax switchport trunk native vlan vlan-id no switchport trunk native vlan • vlan-id-Valid VLAN ID of the active VLAN. Default Configuration VLAN ID=1 Command Mode Interface Configuration (Ethernet, port-channel) mode User Guidelines This command has the following consequences: incoming untagged frames are assigned to this VLAN and outgoing traffic in this VLAN on this port is sent untagged (despite the normal situation where traffic sent from a trunk-mode port is all tagged). The command adds the port as a member in the VLAN. If the port is already a member in the VLAN (not as a native), it should be first removed from the VLAN. Example The following example g8, in trunk mode, is configured to use VLAN number 123 as the "native" VLAN. Console (config)# interface ethernet g8 Console (config-if)# switchport trunk native vlan 123 switchport general allowed vlan The switchport general allowed vlan interface configuration command adds or removes VLANs from a general port. 458 VLAN Commands