Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 230
show ip igmp groups, Protocol IGMP.
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 230 highlights
www.dell.com | support.dell.com Command Mode User EXEC mode User Guidelines There are no user guidelines for this command. Example The following example displays IGMP related information about an interface. Console# show ip igmp interface Interface Version Query Last Max Querier Interval Member response router [sec] [mSec] [Sec] eth g1 2 60 1000 10 198.92.37.33 eth g2 60 1000 10 198.92.36.131 The following table describes the fields shown in the display: Field Interface IP address Version Query interval Last member Max response Querier router Description Interface type, number. Interface IP address. The version of IGMP running on this interface. The frequency (seconds) at which IGMP Host-Query packets are transmitted. The Last Member Query Interval (milliseconds) is the Max Response Time inserted into Group-Specific Queries sent in response to Leave Group messages, and is also the amount of time between Group-Specific Query messages. The maximum query response time (seconds) advertised in IGMPv2 queries. The address of the querier router on the subnet. show ip igmp groups The show ip igmp groups user EXEC command displays the Multicast groups with receivers that are directly connected to the router, and that were learned through Internet Group Management Protocol (IGMP). 230 Multicast Routing Commands