Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 431
traceroute, show system id
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 431 highlights
Example The following example displays the system service tag information. Console> show system id Service Tag: 89788978 Serial number: 8936589782 Asset tag: 7843678957 traceroute The traceroute user EXEC command discovers the IP routes that packets actually take when traveling to their destinations. Syntax traceroute {ip-address |hostname }[size packet_size] [ttl max-ttl] [count packet_count] [timeout time_out] [source ip-address] [tos tos] • ip-address - Valid IP address of the destination host. For information on specifying an out-of-band IP address, see the user guidelines. • hostname - Hostname of the destination host. (Range: 1 - 158 characters) • packet_size - Number of bytes in a packet. (Range: 40-1472) • max-ttl - The largest TTL value that can be used. The traceroute user EXEC command terminates when the destination is reached or when this value is reached. (Range:1-255) • packet_count - The number of probes to be sent at each TTL level. (Range:1-10) • time_out - The number of seconds to wait for a response to a probe packet. (Range:160) • ip-address - One of the interface addresses of the device to use as a source address for the probes. The device will normally pick the valid IP address it considers to be the best source address to use. • tos - The Type-Of-Service byte in the IP Header of the packet. (Range: 0-255) Default Configuration packet_size - The default is 40 bytes. max-ttl - The default is 30. packet_count - The default count is 3. time_out - The default is 3 seconds. System Management 431