Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 312
police aggregate
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 312 highlights
www.dell.com | support.dell.com Example The following example defines a policer for classified traffic. When the average traffic rate exceeds 124000 bps or the normal burst size exceeds 96000 bps, the packet is dropped. The class is in a policy map called "policy1". Console (config)# policy-map policy1 Console (config-pmap)# class class1 Console (config-pmap-c)# police 124000 9600 exceed-action drop police aggregate The police aggregate policy-map class configuration mode command applies an aggregate policer to multiple classes within the same policy map. To remove an existing aggregate policer from a policy map, use the no form of this command. Syntax police aggregate aggregate-policer-name no police aggregate • aggregate-policer-name-Specifies the name of an existing aggregate policer defined in the qos aggregate-policer command. Default Configuration This command has no default configuration. Command Mode Policy-map Class Configuration mode User Guidelines An aggregate policer cannot be used across different policy maps or interfaces. Example The following example sets the aggregate meter "policer1" to a class-map. The class is in a policy map called "policy1". Console (config)# policy-map policy1 Console (config-pmap)# class class1 Console (config-pmap-c)# police aggregate policer1 312 QoS Commands