Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 361

• type router-Indicates that a community is used for SNMP access to the device only (not to the Out-of-Band port). • type oob-Indicates that a community is used for SNMP access to the Out-of-Band port only. Default Configuration No community is defined. Command Mode Global Configuration mode User Guidelines The view-name parameter cannot be specified for su, which has access to the whole MIB. The view-name parameter can be used to restrict the access rights of a community string. When it is specified: • An internal security name is generated. • The internal security name for SNMPv1 and SNMPv2 security models is mapped to an internal group name. • The internal group name for SNMPv1 and SNMPv2 security models is mapped to a view-name (read-view and notify-view always, and for rw for write-view also) The group-name parameter can also be used to restrict the access rights of a community string. When it is specified: • An internal security name is generated. • The internal security name for SNMPv1 and SNMPv2 security models is mapped to the group name. To define a management station on the out-of-band port, use out-of-band IP address format oob/ip-address. For a user to define OOB management port configurations, such as ip address, default gateway, RADIUS, and so forth, two SNMP communities must be defined. A super user can configure OOB management port settings with a single community, by switching between the two communities. Examples The following example configures community access string public to permit administrative access to SNMP at an administrative station with IP address 192.168.1.20. Console (config)# snmp-server community public su 192.168.1.20 SNMP Commands 361