Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 159

IP Addressing Commands ip address The ip address interface configuration command sets an IP address. To remove an IP address, use the no form of this command. Syntax ip address ip-address {mask | prefix-length} no ip address [ip-address] • ip-address-IP address • mask-The IP address network mask • prefix-length-The number of bits that comprise the IP address prefix. The prefix length must be preceded by a forward slash (/). (Range: 0 -32) Default Configuration No IP address is defined for interfaces. Command Mode Interface configuration (Ethernet, VLAN, port-channel, out-of-band Ethernet) User Guidelines Each part of an IP address must start with a number other than zero. For example, IP address 131.108.1.27 is valid, whereas IP addresses 001.100.192.6 and 192.001.10.3 are invalid. An IP address cannot be configured for a range of interfaces (range context). Up to 5 IP addresses may be defined on the out-of-band port. Example The following example configures VLAN 1 with the IP address 131.108.1.27 and subnet mask 255.255.255.0. Console (config)# interface vlan 1 Console (config-if)# ip address 131.108.1.27 255.255.255.0 IP Addressing Commands 159