Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 243
ospf, IP Interface Configuration mode
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
A default cost can be defined only for a stub area. To define a stub area, use the ospf area stub command. Example The following example specifies a cost of 10000 for the default summary route sent into a stub area number 192.168.3.1. Console (config)# router ospf area 192.168.3.1 default-cost 10000 ospf The ospf interface configuration command creates the OSPF routing process on an interface. To delete the OSPF routing process, use the no form of this command. Syntax ospf [area-id] no ospf • Area-id is an area associated with the OSPF address range. It can be specified as either a decimal value or as an IP address. Default Configuration OSPF is not created on an interface. Command Mode IP Interface Configuration mode User Guidelines After creating an OSPF process on an interface, the OSPF process must be activated on the interface using the ospf enable command. If the specified area-id has not yet been created, using the ip interface configuration ospf area command, then it is auto-created using this command. • An OSPF area that is auto-created is not displayed in the configuration file. • An auto-created OSPF area is deleted only after a subsequent reboot, if the OSPF interface is deleted. If no area is designated, the backbone area is associated with the IP interface. If the backbone has not yet been created, it is auto-created. Note that the negation of the area command does not appear in the configuration file, because it is, in fact, the default. However, it does appear when using the show ospf command, because it was automatically created. OSPF Commands 243