Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 28
ACL Commands, Address Table Commands - switch
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
www.dell.com | support.dell.com ACL Commands Command Group ip access-list permit (IP) deny (IP) mac access-list permit (MAC) deny (MAC) service-acl show access-lists show interfaces access-lists Description Mode Creates IP ACLs, and enters to IP- GC Access list configuration mode. Allows traffic if the conditions IP defined in the permit statement are matched. Denies traffic if the conditions IP define in the deny statement are matched Creates Layer 2 MAC ACLs, and GC enters to MAC-Access list configuration mode. Allows traffic if the conditions MT defined in the permit statement are matched. Allows traffic if the conditions MT defined in the permit statement are matched. Applies an access-list to the input IC of an interface. Displays access control lists PE (ACLs) defined on the switch. Displays access lists applied on PE interfaces. Address Table Commands Command Group bridge address bridge multicast filtering bridge multicast address bridge multicast forbidden address bridge multicast forward-all Description Adds a static MAC-layer station source address to the bridge table. Enables filtering of Multicast addresses. Registers MAC-layer Multicast addresses to the bridge table, and adds static ports to the group. Forbids adding a specific Multicast address to specific ports. Mode VC GC VC VC Enables forwarding of all Multicast packets on a port. VC 28 Command Groups