Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 185
key (key chain), key-chain
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Example The following example identifies an authentication keygroup called "M". Console (config)# key-chain M key (key chain) The key key chain configuration command defines an authentication key on a key chain. To remove the key from the key chain, use the no form of this command. Syntax key key-id no key key-id • key-id-An authentication key identification number on a key chain. (Range: 1 - 255) Default Configuration No key exists on the key chain. Command Mode Key chain configuration mode User Guidelines It is useful to have multiple keys on a key chain so that the software can sequence through the keys as they become invalid after time, based on the accept-lifetime and send-lifetime key chain key command settings. Authentication keys and their key strings, which are to be included in the key chain should be defined prior to configuring the key chain. Authentication keys are defined by the key (global) command If the last key expires, authentication stops and an error message is generated. Example The following example identifies two authentication keys, number 1 and 2, on a key chain keygroup called "M". Console (config)# key-chain M Console (config-keychain)# key 1 Console (config-keychain)# key 2 IP Routing Protocol-Independent Commands 185