Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 328
rip default-route offset
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 328 highlights
www.dell.com | support.dell.com Syntax rip default-route originate metric no rip default-route originate • metric-Metric for a default route. (Range: 1- 15) Default Configuration By default, the feature is enabled. Command Mode IP Interface Configuration mode User Guidelines This command is equivalent to rip default-route offset. Note that this is an origination of a default route with the given metric. Setting the value of the metric to 0 is the same as negating the command. An interface on which this command has been configured does not accept "default route" advertisement, in order to prevent a possible loop on the default route. Example The following example applies a metric of 5 to generate a default route to RIP on IP address 100.1.1.1 Console(config)# interface ip 100.1.1.1 Console(config-ip)# rip default-route originate 5 rip default-route offset The rip default-route offset interface configuration command generates an offset for a default route into RIP. To disable this feature, use the no form of this command. Syntax rip default-route offset offset no rip default-route offset • offset-Offset being applied. (Range: 0- 15) Default Configuration By default, the feature is enabled. Command Mode IP Interface Configuration mode 328 RIP Commands