Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 248
ospf retransmit-interval
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
www.dell.com | support.dell.com Default Configuration The default IP Interface dead-interval time is 40 seconds. Command Mode IP Interface Configuration User Guidelines The interval is advertised in router hello packets. This value must be the same for all routers and access servers on a specific network. Example The following example defines the OSPF dead-interval time of 100 seconds on interface 1.100.100.100. Console(config)# interface ip 1.100.100.100 Console(config-ip)# ospf dead-interval 100 ospf retransmit-interval The ospf retransmit-interval interface configuration command specifies the time between linkstate advertisement (LSA) retransmissions for interface adjacencies belonging to the interface. To return to the default value, use the no form of this command. Syntax ospf retransmit-interval seconds no ospf retransmit-interval • seconds-Time (in seconds) between retransmissions. The time must be greater than the expected round-trip delay between any two routers on the attached network. (Range: 1 - 3600) Default Configuration The default time is 5 seconds. Command Mode IP Interface Configuration User Guidelines When a router sends an LSA to its neighbor, it keeps the LSA until it receives back the acknowledgment message. If the router receives no acknowledgment, it resends the LSA. Setting this parameter should be conservatively configured, or unnecessary retransmission can result. 248 OSPF Commands