Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 87
Address Table Commands, bridge address - reset defaults
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Address Table Commands bridge address The bridge address VLAN interface configuration command adds a static MAC-layer station source address to the bridge table. To delete the MAC address, use the no form of the bridge address command (using the no form of the command without specifying a MAC address deletes all static MAC addresses belonging to this VLAN). Syntax bridge address mac-address {ethernet interface | port-channel port-channel-number} [permanent | delete-on-reset | delete-on-timeout | secure] no bridge address [mac-address] • mac-address-A valid MAC address. • interface-A valid Ethernet port. • port-channel-number-A valid port-channel number. • permanent-The address can only deleted by the no bridge address command. • delete-on-reset-The address is deleted after reset. • delete-on-timeout-The address is deleted after "age out" time has expired. • secure-The address is deleted after the port changes mode to unlock learning (no port security command). This parameter is only available when the port is in learning locked mode. Default Configuration No static addresses are defined. The default mode for an added address is permanent. Command Mode Interface configuration (VLAN) mode User Guidelines There are no user guidelines for this command. Address Table Commands 87