Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 208
permit (management)
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
www.dell.com | support.dell.com The following example shows how to create an access-list called "mlist", configure all interfaces to be management interfaces except interfaces ethernet g1 and ethernet g9, and make the access-list the active list. Console (config)# management access-list mlist Console (config-macl)# deny ethernet g1 Console (config-macl)# deny ethernet g9 Console (config-macl)# permit Console (config-macl)# exit Console (config)# management access-class mlist permit (management) The permit management access-list configuration command defines a permit rule. Syntax permit [ethernet interface-number | vlan vlan-id | port-channel number | out-of-band-eth oob-interface] [service service] permit ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-id | port-channel number | out-of-band-eth oob-interface] [service service] • ethernet interface-number-A valid Ethernet port number. • vlan vlan-id-A valid VLAN number. • port-channel number-A valid port channel number. • ip-address-Source IP address. • mask mask-Specifies the network mask of the source IP address. • mask prefix-length-Specifies the number of bits that comprise the source IP address prefix. The prefix length must be preceded by a forward slash (/). • service service-Indicates service type. Can be one of the following: telnet, ssh, http, https or snmp. • out-of-band-eth oob-interface-Out-of-band Ethernet port number. Default Configuration This command has no default configuration. Command Mode Management Access-list Configuration mode 208 Management ACL