Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 221
show ip mroute ethernet, show ip mroute group
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
The following example displays all ip mroutes for port g1. Console# show ip mroute ethernet g1 Group Source Upstream Interface Up Time Owner 224.0.255.1 198.92.37.100/32 10.20.37.33 eth g1 20:20:00 dvmrp 224.0.255.1 199.92.37.100/32 10.20.37.33 eth g1 1d:4h:20m dvmrp 224.1.255.1 198.92.37.100/32 10.20.37.33 eth g1 21:20:00 dvmrp 224.1.255.1 199.92.37.100/32 10.20.37.33 eth g1 1d:5h:20m dvmrp The following example displays all ip mroutes for group 224.1.255.1. Console# show ip mroute group 224.1.255.1 Group Source Upstream Interface Up Time Owner 224.1.255.1 198.92.37.100/32 10.20.37.33 eth g1 21:20:00 dvmrp 224.1.255.1 199.92.37.100/32 10.20.37.33 eth g1 1d:5h:20m dvmrp The following table describes the fields shown in the display: Field Group Source Upstream Interface Up time Expiry time Owner Description IP Multicast group address. The network address that identifies the sources. The upstream neighbor (RPF) address from which IP datagrams from these sources, to this Multicast address are received. The IP interface on which IP datagrams sent by these sources to this Multicast address are received. The time since the Multicast routing information was learned by the router. The minimum amount of time remaining before this entry is aged out. The Multicast routing protocol via which this Multicast forwarding entry was learned. Multicast Routing Commands 221