Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 242
router ospf area default-cost
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
www.dell.com | support.dell.com User Guidelines The router ospf area stub command must be configured on all routers and access servers in the stub area. Use the area router configuration command with the default-cost option to specify the default internal router cost sent into a stub area by an ABR. There are two stub area router configuration commands: the stub and default-cost options of the area router configuration command. In all routers attached to the stub area, the area should be configured as a stub area using the area command stub option. Use the default-cost option only on an ABR attached to the stub area. The default-cost option provides the metric for the summary default route generated by the ABR into the stub area. If a question mark is specified at the end of the router ospf area stub command, the same hint is displayed twice at the prompt line. Example The following example defines an OSPF stub area 7.7.7.7. Console (config)# router ospf area 7.7.7.7 stub router ospf area default-cost The router ospf area default-cost global configuration command specifies a cost for the default summary route sent into a stub area. To remove the assigned default route cost, use the no form of this command. Syntax router ospf area area-id default-cost cost no router ospf area area-id default-cost • area-id-Area associated with the OSPF address range. It can be specified as either a decimal value or as an IP address. • cost-Cost for the default summary route used for a stub area. (Range: 1 - 16777215) Default Configuration A default value is automatically calculated by the router according to RFC 1850. Command Mode Global Configuration mode User Guidelines A default cost can be defined for an area, only after it has been defined. To define an area, use the ospf area command. 242 OSPF Commands