Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 30
Configuration and Image Files Commands, DHCP Relay Commands, Ethernet Configuration Commands
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
www.dell.com | support.dell.com show sntp configuration Displays the SNTP configuration PE show sntp status Displays the SNTP status PE Configuration and Image Files Commands Command Group configure copy delete startup-config boot system show running-config show startup-config show backup-config show bootvar Description Enters the global configuration mode. Copies files from a source to a destination. Deletes the startup-config file. Specifies the system image that the device loads at startup. Displays the contents of the currently running configuration file. Displays the startup configuration file contents. Displays the backup configuration file contents. Displays the active system image file that the device loads at startup. Mode PE PE PE PE PE PE PE PE DHCP Relay Commands Command Group ip dhcp relay enable ip dhcp relay address show ip dhcp relay Description Enables DHCP relay features on the router. Defines the DHCP address available for the DHCP relay. Displays the DHCP relay server addresses. Mode GC GC PE Ethernet Configuration Commands Command Group interface ethernet interface range ethernet interface out-of-band-eth shutdown description Description Enters the interface configuration mode to configure an Ethernet type interface. Enters the interface configuration mode to configure multiple Ethernet type interfaces. Configures the out-of-band Ethernet port and enter interface configuration mode. Disables interfaces. Adds a description to an interface. Mode GC GC IC IC IC 30 Command Groups