Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 217
ip igmp query-max-response-time, Management Protocol IGMP queries. Range: 0 - 25
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
Example The following example configures the frequency at which the software sends IGMP group-specific query messages on port g5 to 20 seconds. Console (config)# interface ethernet g5 Console (config-if)# ip igmp last-member-query-interval 20 ip igmp query-max-response-time The ip igmp query-max-response-time interface configuration command configures the maximum response time advertised in Internet Group Management Protocol (IGMP) queries. To restore the default response time, use the no form of this command. Default Configuration The default frequency is 10 seconds. Syntax ip igmp query-max-response-time seconds [tenths-of-seconds] no ip igmp query-max-response-time • seconds-The maximum response time, in seconds, advertised in Internet Group Management Protocol (IGMP) queries. (Range: 0 - 25) • tenths-of-seconds-Additional tenths of seconds to add to the defined seconds. (Range: 0 - 9) Default Configuration This command has no default configuration. Command Mode Interface configuration (Ethernet, VLAN, port-channel) User Guidelines IGMP must be enabled before setting the response time. If IGMP is disabled on an interface, the IGMP parameters on the interface return to the default values. Multicast Routing Commands 217