Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 434

www.dell.com | support.dell.com The following table describes the characters that can appear in the traceroute user EXEC command output. Field Description * The probe timed out. ? Unknown packet type. A Administratively unreachable. Usually, this output indicates that an access list is blocking traffic. F Fragmentation is required, and DF is set. H Host unreachable. N Network unreachable. P Protocol unreachable. Q Source quench. R Fragement reassembly time exeeded. S Source route failed. U Port unreachable. telnet The telnet user EXEC command logs into a host that supports Telnet. Syntax telnet {ip-address | hostname} [port] [keyword1......] • ip-address - Valid IP address of the destination host. For information on specifying an out-of-band IP address, see the user guidelines. • hostname - Hostname of the destination host. (Range: 1 - 158 characters) • port - A decimal TCP port number, or one of the keywords from the ports table in the user guidelines. • keyword - One or more keywords from the keywords table in the user guidelines. Default Configuration port - Telnet port (decimal 23) on the host. Command Mode User EXEC mode User Guidelines Telnet software supports special Telnet commands in the form of Telnet sequences that map generic terminal control functions to operating system-specific functions. To issue a special Telnet command, press Esc and then a command character. 434 System Management