Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 81
Permit (mac), Hh:hh:hh:hh:hh:hh Or Xxxx.xxxx.xxxx.
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
User Guidelines ACLs on this system perform both access control and layer 2 field classification. To define Layer 2 access lists, the mac access-list command should be used. ACLs cannot be removed when they are applied to an interface (using service-acl command). MAC named lists are used with VLAN maps and class maps. Entering the mac access-list command enables the MAC-access list configuration mode. Example The following example creates a MAC ACL with the name "dell". Console (config)# mac access-list dell Console (config-mac-al)# permit (MAC) The permit mac-acl configuration mode command allows traffic if the conditions defined in the permit statement are matched. Syntax permit {any | {host source source-wildcard}} {any | {destination destination-wildcard}} [vlan vlan-id] • Source MAC address can be one of the following: - any-Packets received from any MAC address. - source source-wildcard-MAC address and wildcard for host from which the packet is sent. Specify the MAC address and wildcard using hexadecimal format (HH:HH:HH:HH:HH:HH) or XXXX.XXXX.XXXX. • Destination MAC address can be one of the following: - any-Packets sent to any MAC address. - destination destination-wildcard-MAC address and wildcard for host to which the packet is sent. Specify the MAC address and wildcard using hexadecimal format (HH:HH:HH:HH:HH:HH) or XXXX.XXXX.XXXX. • vlan vlan-id-The packet VLAN. Default Configuration This command has no default configuration. Command Mode Mac-ACL Configuration mode ACL Commands 81