Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 152

www.dell.com | support.dell.com Command Mode Interface Configuration (Ethernet, port-channel) mode User Guidelines An access port would not dynamically join a VLAN because it is always a member in only one VLAN. Example The following example enables GVRP on ethernet g8. Console (config)# interface ethernet g8 Console (config-if)# gvrp enable garp timer The garp timer interface configuration command adjusts the GARP application join, leave, and leaveall GARP timer values. To reset the timer to default values, use the no form of this command. Syntax garp timer {join | leave | leaveall} timer_value no garp timer • join-Indicates the time in milliseconds that PDUs are transmitted. (Range: 10-2147483640) • leave-Indicates the amount of time in milliseconds that the device waits before leaving its GARP state. The Leave Time is activated by a Leave All Time message sent/received, and cancelled by the Join message. (Range: 10-2147483640) • leaveall-Used to confirm the port within the VLAN. The time in milliseconds between messages sent. (Range: 10-2147483640) • timer_value-Timer values in milliseconds. Default Configuration The default timer values are as follows: • Join timer-200 milliseconds • Leave timer-600 milliseconds • Leavall timer-10000 milliseconds Command Mode Interface configuration (Ethernet, port-channel) mode 152 GVRP Commands