Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 327

Example The following example specifies a RIP version 1 on IP address 100.1.1.1. Console(config)# interface ip 100.1.1.1 Console(config-ip)# rip version 1 rip offset The rip offset interface configuration command adds an offset to a metric learned via Routing Information Protocol (RIP) before adding it to the interface table. To return to the default, use the no form of this command. Syntax rip offset offset no rip offset • offset-Offset being applied. (Range: 1 - 15) Default Configuration The default offset value is 1. Command Mode IP Interface Configuration mode User Guidelines This option is used to make the device prefer RIP routes learned from the specific interfaces less than RIP routes from other interfaces. Example The following example applies an offset of 5 to a metric learned via RIP before adding it to the interface table on IP address 100.1.1.1. Console(config)# interface ip 100.1.1.1 Console(config-ip)# rip offset 5 rip default-route originate The rip default-route originate interface configuration command generates a metric for a default route into RIP. To disable this feature, use the no form of this command. RIP Commands 327