Dell PowerConnect 6024 Command Line Interface (CLI) Guide (.htm) - Page 46
VLAN Commands
View all Dell PowerConnect 6024 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
www.dell.com | support.dell.com VLAN Commands Command Group vlan database vlan interface vlan interface range vlan name switchport mode switchport access vlan switchport trunk allowed vlan switchport trunk native vlan switchport general allowed vlan switchport general pvid switchport general ingressfiltering disable switchport general acceptableframe-type tagged-only switchport forbidden vlan switchport protected map protocol protocols-group switchport general map protocols-group vlan show vlan show vlan internal usage show vlan protocols-groups show interfaces switchport Description Enters the VLAN database configuration mode. Creates a VLAN. Enters the interface configuration (VLAN) mode. Enters the interface configuration mode to configure multiple VLANs. Configures a name to a VLAN. Configures the VLAN membership mode of a port. Configures the VLAN ID when the interface is in access mode. Adds or removes VLANs from a port in general mode. Defines the port as a member of the specified VLAN, and the VLAN ID is the "port default VLAN ID (PVID)". Adds or removes VLANs from a general port. Configures the PVID when the interface is in general mode. Disables port ingress filtering. Mode GC VC GC GC VC IC IC IC IC IC IC IC Discards untagged frames at ingress. IC Forbids adding specific VLANs to a port. IC Overrides the FDB decision and sends all Unicast, Multicast and IC Broadcast traffic to an uplink port. Adds a special protocol to a named group of protocols, which may be VC used for protocol-based VLAN assignment. Sets a protocol-based classification rule. IC Displays VLAN information. PE Displays a list of VLANs being used internally by the switch. PE Displays protocols-groups information. PE Displays switchport configuration. PE 46 Command Groups