HP rp3440 User Service Guide, Sixth Edition - HP 9000 rp3410/rp3440 - Page 21
PCI Riser, Internal Core I/O, Power Supply Unit, MB, 512 MB, and 1 GB, 2 GB
View all HP rp3440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
- 6 GB (HP 9000 rp3410 server), 24 GB (HP 9000 rp3440 server with 2 GB DIMMs installed in all 12 slots), or - 32 GB (HP 9000 rp3440 server with 4 GB DIMMs installed in the first eight slots) • For the HP 9000 rp3410 server, DIMMs are as follows: - 256 MB, 512 MB, and 1 GB - standard 184 pins 2.5V - DDR266, CL2, registered, ECC • For the HP 9000 rp3440 server, DIMMs are as follows: - 256 MB, 512 MB, and 1 GB, 2 GB, 4 GB - standard 184 pins 2.5V - DDR266, CL2, registered, ECC • Only one supported configuration for 4 GB DIMMs; 2 quads (8 DIMMs); and no other DIMMs can be installed. • DIMMs loaded by quads enable interleaved mode and chip spare. • Memory is loaded across both memory busses (two DIMMs on each bus) to ensure maximum bandwidth and performance. • 133 MHz memory bus frequency, 266 MTransfers/s data, 8.5 GB/s peak data bandwidth. • Total memory bandwidth is 8.5 GB/s, split across two 4.25 GB/s memory buses. • Open page memory latency is 80 nanoseconds. PCI Riser Two (HP 9000 rp3410 server) or four (HP 9000 rp3440 server) independent PCI-X 133 MHz 64-bit 3.3V 15W slots. No 5V card and hot-pluggable support. Internal Core I/O The following is supported on the HP 9000 rp3410 and rp3440 servers: • Dual-channel SCSI U160 interface, two internal 68-pin connectors, one 68-pin external connector. • SCSI backplane configured either as two channels with 2+1 drives. A SAF-TE accessory (currently not available) is required to configure the SCSI backplane as one channel with three drives. • Three internal SCSI drive connectors are of the 80-pin type and provide drive electrical hot-pluggable capability. • SCSI backplane is designed to support a SCSI management piggy board accessory that provides a SCSI management SAF-TE chip and shunts the backplane's channels A and B to provide three disks on channel A and leave only the external connector on channel B. • One internal IDE connector for a slim-line optical device (CD and DVD). • No floppy connector. External Core I/O The following is supported on the HP 9000 rp3410 and rp3440 servers: • One SCSI U160 68-pin connector. • One 10/100/1000Base-T Ethernet LAN connectors for copper cable. • Four USB 2.0 ports. • Three DB-9 ports (console, UPS, and modem) through a 3-connector M cable. Power Supply Unit The following is supported on the HP 9000 rp3410 and rp3440 servers: Detailed Server Description 21