Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 101

ProSafe Managed Switch dot1x timeout This command sets the value, in seconds, of the timer used by the authenticator state machine on this port. Depending on the token used and the value (in seconds) passed, various timeout configurable parameters are set. The following tokens are supported: Tokens Definition guest-vlan-period The time, in seconds, for which the authenticator waits to see if any EAPOL packets are received on a port before authorizing the port and placing the port in the guest vlan (if configured). The guest vlan timer is only relevant when guest vlan has been configured on that specific port. reauth-period The value, in seconds, of the timer used by the authenticator state machine on this port to determine when re-authentication of the supplicant takes place. The reauth-period must be a value in the range 1 - 65535. quiet-period The value, in seconds, of the timer used by the authenticator state machine on this port to define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must be a value in the range 0 - 65535. tx-period The value, in seconds, of the timer used by the authenticator state machine on this port to determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period must be a value in the range 1 - 65535. supp-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535. server-timeout The value, in seconds, of the timer used by the authenticator state machine on this port to timeout the authentication server. The supp-timeout must be a value in the range 1 65535. Default Format Mode • guest-vlan-period: 90 seconds • reauth-period: 3600 seconds • quiet-period: 60 seconds • tx-period: 30 seconds • supp-timeout: 30 seconds • server-timeout: 30 seconds dot1x timeout {{guest-vlan-period } |{reauth-period } | {quiet-period } | {tx-period } | {supp-timeout } | {server-timeout }} Interface Config no dot1x timeout This command sets the value, in seconds, of the timer used by the authenticator state machine on this port to the default values. Depending on the token used, the corresponding default values are set. Format Mode no dot1x timeout {guest-vlan-period | reauth-period | quiet-period | tx-period | supp-timeout | server-timeout} Interface Config Switching Commands 101