Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 259

ProSafe Managed Switch source. This is typically used for preventing routing loops. The reject route added in the RTO is of the type OSPF Inter-Area. Reject routes (routes of REJECT type installed by any protocol) are not redistributed by OSPF/RIP. Reject routes are supported in both OSPFv2 and OSPFv3. The following shows example CLI display output for the command. (Switch) #show ip route Route Codes: R - RIP Derived, O - OSPF Derived, C - Connected, S - Static B - BGP Derived, IA - OSPF Inter Area E1 - OSPF External Type 1, E2 - OSPF External Type 2 N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA External Type 2 C 1.1.1.0/24 [0/1] directly connected, 0/11 C 2.2.2.0/24 [0/1] directly connected, 0/1 C 5.5.5.0/24 [0/1] directly connected, 0/5 S 7.0.0.0/8 [1/0] directly connected, Null0 OIA 10.10.10.0/24 [110/6] via 5.5.5.2, 00h:00m:01s, 0/5 C 11.11.11.0/24 [0/1] directly connected, 0/11 S 12.0.0.0/8 [5/0] directly connected, Null0 S 23.0.0.0/8 [3/0] directly connected, Null0 show ip route ecmp-groups This command reports all current ECMP groups in the IPv4 routing table. An ECMP group is a set of two or more next hops used in one or more routes. The groups are numbered arbitrarily from 1 to n. The output indicates the number of next hops in the group and the number of routes that use the set of next hops. The output lists the IPv4 address and outgoing interface of each next hop in each group. Format Mode show ip route ecmp-groups Privileged EXEC Example (switch) #show ip route ecmp-groups ECMP Group 1 with 2 next hops (used by 1 route) 172.20.33.100 on interface 2/33 172.20.34.100 on interface 2/34 ECMP Group 2 with 3 next hops (used by 1 route) 172.20.32.100 on interface 2/32 172.20.33.100 on interface 2/33 172.20.34.100 on interface 2/34 ECMP Group 3 with 4 next hops (used by 1 route) 172.20.31.100 on interface 2/31 172.20.32.100 on interface 2/32 172.20.33.100 on interface 2/33 172.20.34.100 on interface 2/34 Routing Commands 259