Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 306
This command displays information relevant to the OSPF router.
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 306 highlights
ProSafe Managed Switch show ip ospf This command displays information relevant to the OSPF router. Format Mode show ip ospf Privileged EXEC Note: Some of the information below displays only if you enable OSPF and configure certain features. Term Definition Router ID A 32-bit integer in dotted decimal format identifying the router, about which information is displayed. This is a configured value. OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a configured value. ASBR Mode Indicates whether the ASBR mode is enabled or disabled. Enable implies that the router is an autonomous system border router. Router automatically becomes an ASBR when it is configured to redistribute routes learnt from other protocol. The possible values for the ASBR status is enabled (if the router is configured to re-distribute routes learned by other protocols) or disabled (if the router is not configured for the same). RFC 1583 Indicates whether 1583 compatibility is enabled or disabled. This is a configured value. Compatibility External LSDB The maximum number of non-default AS-external-LSA (link state advertisement) entries Limit that can be stored in the link-state database. Exit Overflow Interval The number of seconds that, after entering overflow state, a router will attempt to leave overflow state. Spf Delay Time The number of seconds between two subsequent changes of LSAs, during which time the routing table calculation is delayed. Spf Hold Time The number of seconds between two consecutive spf calculations. Flood Pacing Interval The average time, in milliseconds, between LS Update packet transmissions on an interface. This is the value configured with the timers pacing flood command. LSA Refresh Group Pacing Time The size, in seconds, of the LSA refresh group window. This is the value configured with the timers pacing lsa-group command. Opaque Capability Shows whether the router is capable of sending Opaque LSAs. This is a configured value. Autocost Ref BW Shows the value of auto-cost reference bandwidth configured on the router. ABR Status Shows whether the router is an OSPF Area Border Router. Routing Commands 306