Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 472

ProSafe Managed Switch match ethertype This command adds to the specified class definition a match condition based on the value of the ethertype. The value is specified as one of the following keywords: appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom ethertype value in the range of 0x0600-0xFFFF. Format Mode match ethertype { | custom } Class-Map Config Ipv6-Class-Map Config match any This command adds to the specified class definition a match condition whereby all packets are considered to belong to the class. Default Format Mode none match any Class-Map Config Ipv6-Class-Map Config match class-map This command adds to the specified class definition the set of match conditions defined for another class. The is the name of an existing DiffServ class whose match conditions are being referenced by the specified class definition. Default Format Mode none match class-map Class-Map Config Ipv6-Class-Map Config Note the following: • The parameters and can not be the same. • Only one other class may be referenced by a class. • Any attempts to delete the class while the class is still referenced by any fails. • The combined match criteria of and must be an allowed combination based on the class type. • Any subsequent changes to the class match criteria must maintain this validity, or the change attempt fails. • The total number of class rules formed by the complete reference class chain (including both predecessor and successor classes) must not exceed a platform-specific maximum. Quality of Service (QoS) Commands 472