Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 45

ProSafe Managed Switch show port status This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group. Format Mode show port status { | all} Privileged EXEC Term Interface Media Type STP Mode Physical Mode Physical Status Link Status Loop Status Partner Flow Control Definition Valid slot and port number separated by forward slashes. "Copper" or "Fiber" for combo port. Indicate the spanning tree mode of the port. Either "Auto" or fixed speed and duplex mode. The actual speed and duplex mode. Whether the link is Up or Down. Whether the port is in loop state or not. Whether the remote side is using flow control or not. Loopback Interface Commands The commands in this section describe how to create, delete, and manage loopback interfaces. A loopback interface is always expected to be up. This interface can provide the source address for sent packets and can receive both local and remote packets. The loopback interface is typically used by routing protocols. To assign an IP address to the loopback interface, see ip address on page 247. To assign an IPv6 address to the loopback interface, see ipv6 address on page 377. interface loopback Use this command to enter the Interface Config mode for a loopback interface. The range of the loopback ID is 0 to 7. Format Mode interface loopback Global Config Switching Commands 45