Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 718
network ipv6 gateway, show network ndp
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 718 highlights
ProSafe Managed Switch • Disable the dhcpv6 client protocol on the network port (with the dhcp option). Format Mode no network ipv6 address {address/prefix-length [eui64] | autoconfig | dhcp} Privileged EXEC network ipv6 gateway Use this command to configure IPv6 gateway (default routers) information for the network port. The gateway address is in IPv6 global or link-local address format. Format Mode network ipv6 gateway Privileged EXEC no network ipv6 gateway Use this command to remove IPv6 gateways on the network port interface. Format Mode no network ipv6 gateway Privileged EXEC show network ndp Use this command to display NDP cache information for the network port. Default Format Mode enabled show network ndp • Privileged EXEC • User EXEC Term Definition IPv6 Address The IPv6 address of the interface. MAC Address The MAC Address used. isRtr Specifies the router flag. Neighbor State The state of the neighbor cache entry. Possible values are: Reachable, Delay. Age Updated The time in seconds that has elapsed since an entry was added to the cache. The following shows sample CLI display output for the command: (switch) #show network ndp IPv6 Address 3017::204:76FF:FE73:423A MAC Address 00:04:76:73:42:3a isRtr ----- Neighbor State -------- Reachable Age Updated ------447535 Management Commands 718