Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 498

ProSafe Managed Switch no ip access-list This command deletes the IP ACL identified by from the system. Format Mode no ip access-list Global Config ip access-list rename This command changes the name of an IP Access Control List (ACL). The parameter is the names of an existing IP ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IP access list. This command fails is an IP ACL by the name already exists. Format Mode ip access-list rename Global Config {deny | permit} (IP ACL) This command creates a new rule for the current IP access list. Each rule is appended to the list of configured rules for the list. Note: The "no" form of this command is not supported, since the rules within an IP ACL cannot be deleted individually. Rather, the entire IP ACL must be deleted and re-specified. Note: An implicit "deny all" IP rule always terminates the access list. Note: The mirror parameter allows traffic matching this rule to be copied to the specified , while the redirect parameter allows traffic matching this rule to be forwarded to the specified . The assign-queue and redirect parameters are valid only for a permit rule. A rule might either deny or permit traffic according to the specified classification fields. At a minimum, either the every keyword or the protocol, source address, and destination address values must be specified. The source and destination IP address fields might be specified using the keyword 'any' to indicate a match on any value in that field. The remaining Quality of Service (QoS) Commands 498