Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 520
poe high-power, poe power limit, no poe detection
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 520 highlights
ProSafe Managed Switch no poe detection Use this command to set the detection mode to the default on a global basis or per interface. Format Mode no poe detection Global Config Interface Config poe high-power Use this command to switch a port from 802.3af mode to high-power mode. This mode is used to power up devices that require more power than the current IEEE 802.3af power (more than 12.95 watts at the PD). There are three options: • legacy-Use this mode if the device can power up (more than 12.95 watts) with higher current and it cannot identify itself as a Class 4 device. • Pre-dot3at-Use this mode if the device cannot identify itself as a Class 4 device and it does not have LLDP support. • Dot3at-Use this mode if the device is a Class 4 device capable of figuring out power requirements through 2-event classification or LLDP. Format Mode Default poe high-power {legacy | pre-dot3at | dot3at} Interface Config dot3at no poe high-power Use this command to disable the high-power mode. The port will support only IEEE 902.3af devices. This command works on a global basis or per interface. Format Mode no poe high-power Interface Config poe power limit Use this command to configure the type of power limit for a port. If the power limit type is "user-defined," the command also allows you to configure a maximum power limit. There are three options: • class-based-Allows the port to draw up to the maximum power based on the classification of the device connected. • none-Allows the port to draw up to Class 0 maximum power if it is in low-power mode and up to Class 4 maximum power if it is in high-power mode. Power over Ethernet (PoE) Commands 520