Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 253
encapsulation, clear ip route all, clear ip route counters, show ip brief
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
ProSafe Managed Switch encapsulation This command configures the link layer encapsulation type for the packet. The encapsulation type can be ethernet or snap. Default Format Mode ethernet encapsulation {ethernet | snap} Interface Config Note: Routed frames are always ethernet encapsulated when a frame is routed to a VLAN. clear ip route all This command removes all the route entries learned over the network. Format Mode Protocol Total Number of Routes clear ip route all Privileged EXEC Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or RIP. The total number of routes. clear ip route counters This command resets to zero the IPv4 routing table counters reported in show ip route summary. The command resets only the event counters. Counters that report the current state of the routing table, such as the number of routes of each type, are not reset. Format Mode clear ip route counters Privileged EXEC show ip brief This command displays all the summary information of the IP, including the ICMP rate limit configuration and the global ICMP Redirect configuration. Format Modes show ip brief • Privileged EXEC • User EXEC Routing Commands 253