Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 570
The USB device, ip6address
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 570 highlights
ProSafe Managed Switch Note: is also a valid parameter for routing packages that support IPv6. For switches that support a USB device, the copy command can be used to transfer files from and to the USB device. The syntax for the USB file is: usb://. The USB device can be either a source or destination in the copy command. It cannot be used as both source and destination in a given copy command. Note: Remember to upload the existing Switch CLI.cfg file off the switch prior to loading a new release image in order to make a backup. Parameters for the copy command are listed in the following table: Source nvram:backup-config Destination nvram:startup-config nvram:clibanner nvram:errorlog nvram:log nvram:script nvram:startup-config nvram:backup-config nvram:startup-config nvram:traplog system:running-config nvram:startup-config nvram:clibanner nvram:script Description Copies the backup configuration to the startup configuration. Copies the CLI banner to a server. Copies the error log file to a server. Copies the log file to a server. Copies a specified configuration script file to a server. Copies the startup configuration to the backup configuration. Copies the startup configuration to a server. Copies the trap log file to a server. Saves the running configuration to nvram. Downloads the CLI banner to the system. Downloads a configuration script file to the system. During the download of a configuration script, the copy command validates the script. In case of any error, the command lists all the lines at the end of the validation process and prompts you to confirm before copying the script file. Utility Commands 570