Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 556

ProSafe Managed Switch no logging persistent Use this command to disable the persistent logging in the switch. Format Mode no logging persistent Global Config Email Alerting and Mail Server Commands logging email This command enables email alerting and sets the lowest severity level for which log messages are emailed. If you specify a severity level, log messages at or above this severity level, but below the urgent severity level, are emailed in a non-urgent manner by collecting them together until the log time expires. You can specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Default Format Mode Disabled; when enabled, log messages at or above severity Warning (4) are emailed logging email [] Global Config no logging email This command disables email alerting. Format Mode no logging email Global Config logging email urgent This command sets the lowest severity level at which log messages are emailed immediately in a single email message. Specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none to indicate that log messages are collected and sent in a batch email at a specified interval. Default Format Mode Alert (1) and emergency (0) messages are sent immediately logging email urgent { | none } Global Config Utility Commands 556