Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 463
classofservice trust, cos-queue min-bandwidth, show running config
UPC - 606449080162
View all Netgear GSM7328SO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 463 highlights
ProSafe Managed Switch classofservice trust This command sets the class of service trust mode of an interface. You can set the mode to trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set the interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not appear in the output of the show running config command because Dot1p is the default. Note: The classofservice trust dot1p command will not be supported in future releases of the software because Dot1p is the default value. Use the no classofservice trust command to set the mode to the default value. Default Format Modes dot1p classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted} • Global Config • Interface Config no classofservice trust This command sets the interface mode to the default value. Format Modes no classofservice trust • Global Config • Interface Config cos-queue min-bandwidth This command specifies the minimum transmission bandwidth guarantee for each interface queue. The total number of queues supported per interface is platform specific. A value from 0-100 (percentage of link rate) must be specified for each supported queue, with 0 indicating no guaranteed minimum bandwidth. The sum of all values entered must not exceed 100. Format Modes cos-queue min-bandwidth ... • Global Config • Interface Config Quality of Service (QoS) Commands 463