Netgear GSM7328SO Command Line Interface (CLI) User Manual - Page 335

ProSafe Managed Switch show ip rip This command displays information relevant to the RIP router. Format Modes show ip rip • Privileged EXEC • User EXEC Term RIP Admin Mode Split Horizon Mode Auto Summary Mode Host Routes Accept Mode Global Route Changes Global queries Default Metric Default Route Advertise Definition Enable or disable. None, simple or poison reverse. Enable or disable. If enabled, groups of adjacent routes are summarized into single entries, in order to reduce the total number of entries The default is enable. Enable or disable. If enabled the router accepts host routes. The default is enable. The number of route changes made to the IP Route Database by RIP. This does not include the refresh of a route's age. The number of responses sent to RIP queries from other systems. The default metric of redistributed routes if one has already been set, or blank if not configured earlier. The valid values are 1 to 15. The default route. show ip rip interface brief This command displays general information for each RIP interface. For this command to display successful results routing must be enabled per interface (i.e., ip rip). Format Modes show ip rip interface brief • Privileged EXEC • User EXEC Term Definition Interface Valid slot and port number separated by forward slashes. IP Address The IP source address used by the specified RIP interface. Send Version The RIP version(s) used when sending updates on the specified interface. The types are none, RIP-1, RIP-1c, RIP-2 Receive Version The RIP version(s) allowed when receiving updates from the specified interface. The types are none, RIP-1, RIP-2, Both Routing Commands 335